Hp ilo 4 ports series#
ILO comes preconfigured with proLiant servers of the 300 series and above. This feature can be configured by using the iLO CLI or XML scripting. iLO network connection auto-select-Allows you to configure iLO to automatically select the iLO Dedicated Network Port or Shared Network Port, based on the detected network activity. In some cases, port 2 might not be fully functional. NOTE: Not all sideband NICs are supported. You can configure this setting on the Network > Shared Network Port > General page in the iLO web interface.
Shared Network Port port selection-Allows you to choose between port 1 and port 2 for Shared Network Port functionality. HP RESTful API-The HP RESTful API is a management interface that server management tools can use to perform configuration, inventory, and monitoring of an HP ProLiant server via iLO. Configuring the group memberships of individual systems is still supported. Group configuration for iLO Federation Groups-Allows you to configure groups for the systems in an iLO Federation Management group.
Hp ilo 4 ports license key#
iLO Federation Group License Activation-Supports license key installation on multiple systems. 1 GB Embedded User Partition-Allows you to use a 1 GB non-volatile flash memory partition as if it was an SD-card attached to the server.Įnhancements: Gen 8 and Gen 9 ProLiant Servers HP ProLiant Pre-boot Health Summary-Displays diagnostic information on the server monitor when the server is off and power is available.
Hp ilo 4 ports manual#
Manual iLO reboot via the server UID button-Allows you to use the server UID button to initiate a graceful iLO reboot or a hardware iLO reboot. The CLI hangs after Virtual Media is mounted through a URL.Įnhancements: Gen 9 ProLiant Servers Only The Login Security Banner display on the Login page is incomplete. Characters are missing on the Group Virtual Media page after a disk image is connected through a URL. The 24-hour power graph does not include all available power data.
Hp ilo 4 ports update#
The iLO Firmware cannot be updated via the Group Firmware Update feature. Embedded Remote Support fails after sending a second test service event. The power supply status shows Failed/Good, In Use when the power cord is removed from the server. The character limit for the Server Name is inconsistent between the iLO web interface and the CLI. Users without the Configure iLO Settings privilege can modify iLO ROM-based setup utility settings. An error message is not displayed when an invalid Gateway IPv4 address is configured.
The power supply status for an installed power supply is incorrectly displayed as "Not installed" on the System Information Power Information page in the iLO web interface. The iLO clock is one hour fast during Daylight Savings Time when it is configured by the ROM-based setup utility or the Insight Management Agents.
iLO requires a reset for IPv6 Multicast Scope changes. The System Information Health Summary page shows an Undefined error message on D元80p Gen8 servers. DHCP options can be modified via the ROM-based setup utility when DHCP is disabled. iLO cannot be enabled via the iLO RBSU if it was disabled by using the iLO 4 Configuration Utility in the UEFI System Utilities. The iLO Shared Network Port cannot be enabled for embedded LOM via the ROM-based setup utility or iLO web interface. The error "Max number of certificates has been reached" occurs when SSO certificates are imported.
0 kommentar(er)
